# MathPlayer Navigation Commands in Word

• In NVDA, press NVDA+Alt+M. (The NVDA key is Insert. Caps Lock can also be enabled as an NVDA key.)
• In Window-Eyes, press Ctrl+Shift+A.

• In NVDA, press Esc.
• In Window-Eyes, press Ctrl+Shift+A.

There are two navigation modes, each of which can be set:

• Speech after move mode: Whether the expression is read or described (a summary/outline) after each move.
• Navigation mode: Navigate by subexpression, small piece, or character (shift+down/up arrow will cycle to smaller/larger modes and then wrap around). See next section for explanations of these modes.

NYI = Not Yet Implemented

KeyUnmodified+Ctrl+Shift+Ctrl+Shift
LeftMove to previousIn table: Move to previous cell
In columnar math: Move to previous digit
RightMove to nextIn table: Move to next cell
In columnar math: Move to next digit
UpZoom outIn table: Move to cell above
In columnar math: Move to digit above
Change Navigation Mode (Enhanced/Simple/Character) to largerZoom out all the way
DownZoom inIn table: Move to cell below
In columnar math: Move to digit below
Change Navigation Mode (Enhanced/Simple/Character) to smallerZoom in all the way
EnterWhere am IGlobal where am I
Numbers
1-10 (0 is 10)
HomeMove to start of expressionMove to start of lineMove to start of column
Move to digit at top
NYI: Read from start of expression
EndMove to end of expressionMove to end of lineMove to end of column
Move to digit at bottom
NYI: Read to end of expression
BackspaceMove back to last position
Ctrl+Shift+AEnter/Exit math (Window-Eyes)
NVDA+Alt+MEnter Math (NVDA)
ESCExit Math (NVDA)
• Enhanced mode: Navigation is by mathematically meaningful pieces (operators, delimiters, and operands).
• Simple mode: This moves by words except when you get to a 2D notation (fractions, roots, …), then it speaks the entire notation. Zooming in lets you explore the 2D notation in the same mode. Zooming out or moving out of the 2D notation brings you back to the outer/higher level of navigation.
• Character mode: This is actually two useful modes -- word mode and character mode (zoom in to get "real" character mode). Moves by words/characters. This differs for numbers of more than one digit and function names such as "sin" that are multiple characters. Otherwise, word and character navigation is the same.

Typically, you begin navigating by zooming in (down arrow) one or more levels, and then moving right (right arrow) as desired. Some larger expressions require zooming in again as you move to the right.

Backspace will take you back to where you were, which is not always the same as moving to the left. For example, if right arrow moved you out of a fraction, backspace will take you back to where you were in the denominator and left arrow will land on the entire fraction.